Home/Lock50 Blog/Lock50 HW04 JLR RFA Change when BCM is Locked Demo SW28 Erase BCM Keys
Lock50 HW04 JLR RFA Change when BCM is Locked Demo SW28 Erase BCM Keys
Friday, February 14, 2025
by Lock50 JLR Key Tools
Demo at the Upcoming Show Live
Upgrade your Lock HW04-B or C Models to Latest Software to Allow Swap To New RFA without SWAP BCM and program via OBD New RFA when BCM is Locked for IPCB Digital clusters Models in 5 Minhttps://lock50.co.uk/.../lock50-hw04-obd-tool-jlr-2017.../
???? About this video
Published Feb 14, 2025 on the official Lock50 YouTube channel
This Lock50 demo showcases the SW28 function for unlocking a locked Body Control Module (BCM) in a 2021 Land Rover Range Rover Evoque (L551) after an RFA module swap. Initial attempts to replace the RFA module and learn keys failed due to a locked BCM, returning "less than 2 keys found" error. The SW28 function bypasses this, enabling adaptation of the new RFA and programming of three keys, followed by erasing old keys from the BCM. The tool also clears various diagnostic trouble codes and syncs modules to ensure proper vehicle operation.
What this video covers
Lock50 JLR Key Tool
Land Rover Key Programming
Range Rover Evoque Key Programming
BCM Unlocking Land Rover
RFA Module Replacement
Erase Keys Land Rover
JLR SW28 Function
Locked BCM Bypass
Auto Key Programming Tool
Land Rover Diagnostics
Key Learning JLR
Immobilizer Repair Land Rover
▶ Read the full spoken transcript
Welcome to a Demo of the SW28 Function for Locked BCM systems. This car a New RFA has been swapped and we run the Replace RFA Option as normal. However we notice the BCM processing does not complete and we see this error. This Means the BCM is locked and a RFA alone cannot be learnt without Swapping to New BCM Normally. You can Order the SW28 option for B or C packages to Bypass this and Still be able to Adapt the New RFA without a BCM Change. We are scanning the car agian. Now we use the SW28 Replace RFA when BCM is Locked Function to Adapt the New RFA. All ok and RFA is being Programmed and any error we can check later and clear. All Done and now we shall program 3 keys the client required. Keys Added and now we will erase old keys from BCM and replace with the new Keys. All Done and Ready to Start and we can check the keys that are learnt and can see all. Now we will clear all codes in modules and also syn the BCM to the Door modules agian as due to an erro code that did not complete before fully. The error code the door module still is not allowing the sync so we shall clear codes agian and scan car agian till all codes are cleared and then run agian BCM sync. Note the Car came to the client with all this errors in modules and lock50 is clearing them. Some codes if fail to clear redo when the ignition is on and then will clear also. Now rerunning BCM Sync to Doors for rolling codes. All Done this time Completed. Final scan to check all Error codes are gone. We give the client back the car as it was from the showroom new with latest software in GWM BCM RFA. Thanks for watching the demo of RFA change and erase keys in BCM when BCM is locked with the SW28 Function.