SW200 — D250 to D300 Power Upgrade for Range Rover, Range Rover Sport and Defender. Genuine JLR factory power calibration on the 3.0L Ingenium inline-six diesel (AJ20D6 / AJ200D), selected in software and coded to your VIN over OBD.
Genuine JLR factory calibration selected in the vehicle configuration — fully retained, dealer-safe, and reversible.
The derivative step is a configuration value, not a tuning file. This is what we write:
| CCF address | Parameter | Block | Byte | Bits | Values (from the CCF data set) |
|---|---|---|---|---|---|
| 0x3F87 | Engine Power Output (kW) | 0x3F | 8 | 7–0 | Stored engine output in kW selects the factory calibration. Older data-set labels: 0x0A / 0x0F / 0x14 = AJ200P 200 / 240 / 300 PS. Ingenium I6 and V8 values are read from your VIN’s live As-Built before the change — we do not publish guessed byte values. |
On EVA2 cars the power value is held in the powertrain (PCM) configuration and mirrored in the As-Built record; writing the gateway CCF alone does not change output — the PCM configuration is written and the matching factory calibration re-selected. The value is never auto-flipped: it is set once, to your chosen derivative, against your VIN.
The 3.0L Ingenium I6 MHEV diesel is one engine across D250 / D300 / D350 — the derivative is the calibration:
| Model | Platform | Model years | Notes |
|---|---|---|---|
| Range Rover | L460 | 2022–2026 | D250 / D300 / D350 3.0L Ingenium I6 MHEV diesel offered across the range. |
| Range Rover Sport | L461 | 2022–2026 | D250 / D300 / D350 share one 3.0L Ingenium I6 MHEV engine; output is set by calibration. |
| Defender 90 / 110 / 130 | L663 | 2021–2026 | 3.0L I6 MHEV diesel (D200 / D250 / D300 / D350) from MY2021 — the MY2020 2.0L D200 / D240 four-cylinder is a different engine and is not eligible. D250 / D350 are the main diesels from MY2025. |
Pre-EVA2 cars (L405, L494, L462, L550, L551 etc.) are not eligible for this calibration swap — see the eligibility note above.
Depending on model year and architecture, the D250 → D300 calibration is enabled by one of two methods. We pick the correct one for your VIN — you do not need to know which in advance.
Either route is performed over the OBD diagnostic port, remote and mobile. The engine, turbo and fuel system are the same factory hardware across the derivatives listed — only the selected calibration changes.
© 2016 - 2025 Lock50 is a Trademark Owned by Oliveston Ltd
![]()