Rear Differential Config for Jaguar & Land Rover — Configure rear differential settings – rear e-diff not fitted / fitted. Set in software via the CCF and coded to your VIN / As-Built over the OBD port — remote & mobile.
The dropdown above maps to these values in the Car Configuration File:
| CCF address | Parameter | Block | Byte | Bits | Values (from the CCF data set) |
|---|---|---|---|---|---|
| 0x2327 | Rear Diff | 0x23 | 2 | 7–0 | 01 = Rear e-diff not fitted, 02 = Rear e-diff fitted, 03 = Torque vectoring diff (TVD) fitted. |
The Rear Differential Config option sets the Car Configuration File values above. It needs the locking / active rear differential. Where the hardware is present but the option was never enabled we switch it on; software cannot add hardware that is not fitted — we check your As-Built first and set only what your car carries.
Earliest model year the options existed on each line:
| Model | Platform | Model years | Notes |
|---|---|---|---|
| Range Rover / Range Rover Sport | L405 / L494 | 2013–2022 | Only where the option was offered and the supporting hardware is fitted. |
| Discovery / Defender / Discovery Sport | L462 / L663 / L550 | 2015–2026 | Current Land Rover lines; depends on market and fitted hardware. |
| Range Rover / Range Rover Sport | L460 / L461 | 2022–2026 | Current MLA platforms; flag present where the feature was offered. |
Earliest model years the CCF flag existed on each line; availability depends on fitted hardware and market. We confirm by VIN before any change.
Depending on model year and architecture, Rear Differential Config is enabled by one of two methods. We pick the correct one for your VIN — you do not need to know which in advance.
Either route is performed over the OBD diagnostic port, remote and mobile. Where the feature needs hardware your car does not carry, the hardware must be fitted first — software cannot add it. The change is reversible the same way.
© 2016 - 2025 Lock50 is a Trademark Owned by Oliveston Ltd
![]()